MakerWorld
Hand Tools
Voir le modèle
Stamp with interchangeable inserts and ink holder
9
Téléchargements
7
Likes
0
Makes
When printing stamp, enable supports only for the stamp itself and not the insert.When printing stamp holder also enable supports.For the stamp holder i used approx. 2 cm thick and 6 cm wide sponge.I recommend to sand the insert with fine grit sandpaper.If desired, you can add 5mm wide rubber feet on the bottom of the stamp holder
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !