Stampede Cycle Control Switch Plates

Decided to mock up a couple switch plates for adding a cycle switch to the Stampede. This should eliminate any and all runaway due to over-volting. They're nothing pretty but they work. I'm not a designer in the slightest so if someone wants to take it and run with it, all the better. As it stands its still a work in progress and requires quite a bit of arm bending on the plunger switch to get it working just right

Rear takes a small microswitch with screws (Omron SS-5GL, I used a clone) and the trigger switch takes a standard 15A Omron and is held with 2 short M3 dome head screws.

You will have to cut down the ribbing from the inside of the right grip. The plate is designed to fit snugly where they intersect.