Thingiverse
Stand for PSVR AIM Controller
por Bracketracer
108
Descargas
89
Likes
1
Makes
Table top stand for the Playstation AIM controller. Leaves access for the charge port.
I came here looking for a stand for our new PSVR AIM controller but everything I found was more like a hook or a hanger. I used the canvas mode of Fusion 360 to measure the angles of the controller body and printed a test strip to verify. First try looked good so I ran the whole print. Took a little more than 12 hours to finish in standard mode.
I came here looking for a stand for our new PSVR AIM controller but everything I found was more like a hook or a hanger. I used the canvas mode of Fusion 360 to measure the angles of the controller body and printed a test strip to verify. First try looked good so I ran the whole print. Took a little more than 12 hours to finish in standard mode.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
