Thingiverse
standard limit switch replacement
von Audidude86
21
Downloads
14
Likes
1
Makes
this is a x axis limit switch re-design to house the standard limit switch that comes on most printers. this was created to work with this x axis redesignhttps://www.thingiverse.com/thing:1103976/#files
hope this helps some of you guys out there.
switch dimension are
20mm x 10mm x 6.5mm
x2 M3x10mm screws should hold it in place if not just hot glue it.
rod diameter is 8mm
hope this helps some of you guys out there.
switch dimension are
20mm x 10mm x 6.5mm
x2 M3x10mm screws should hold it in place if not just hot glue it.
rod diameter is 8mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!