Thingiverse
Standard Servo Pan/Tilt Bracket
door POT82ES
3
Downloads
3
Likes
0
Makes
Simple and minimal bracket for connecting two standard sized servos in a pan/tilt configuration. Great for testing without spending too much material.
Should be a tight fit, tested on HiTEC HS-625MG servos. I recommend using M2 or similar sized screws with washers. Minimum amount of screws required is 4, optimally 8.
N.B. You have to print 2 pieces.
Should be a tight fit, tested on HiTEC HS-625MG servos. I recommend using M2 or similar sized screws with washers. Minimum amount of screws required is 4, optimally 8.
N.B. You have to print 2 pieces.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
