Star Wars BB-8 (HueForge)

What you see was printed on my P1S with the colors listed below. It was created by HueForge, a program that takes images and computes the layer thickness and colors required to reproduce with simple filament. Important! A few things to keep in mind: To end up with exactly what you see in the picture, you will need to use the same brand and colors listed below. They can be substituted, but the colors might be different as different filaments can blend differently on top of them being different in color. X and Y can be scaled (preferably by the same %). Z cannot, so make sure you turn off Uniform Scaling in Bambu Studio. This can be printed without an AMS, however you will need to delete the current filament change settings and add layer pauses instead at the *same exact* layer and swap them out manually. If there are over 4 colors, you can use the same slot twice, just make sure you don’t use the same slot back-to-back so you are able to switch out the color while another slot is being