Thingiverse
Starter Block Stand 4x3
von dpaulat
1
Downloads
1
Likes
0
Makes
Designed to hold General Hydroponic Rapid Rooter starter blocks.
It's very strong with a hollow back. Legs are printed sideways for strength.
Remixed from chiphead420's original design, shrinking the grid from 5x3 to 4x3 for smaller printers.
It's very strong with a hollow back. Legs are printed sideways for strength.
Remixed from chiphead420's original design, shrinking the grid from 5x3 to 4x3 for smaller printers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!