Stash Wallet

I was looking for a stash can, however most of them were way too obvious. So i tried to create a stash that i could carry and not raise too many suspicion.
Thinking about it i realised i hated using my wallet, It was just to volumous.

So i went for a wallet where i could carry cards, which is what i mostly use by the way. and a small hole with a screw cap. the hole lenght is roughly 80 mm, and a 8 mm diameter, however the thread took a bit of a 1.5mm off of it which i may fix someday.

the space for the cards is 0.9mm, and has 2 1mm spacers.

if you want to print this, be aware you may want to adjust your slicer setting for horizontal expansion. or the cards and spacers may not fit, as i did not print it yet.

The cap and stash should be completely fine.
The cap has a Pot embossed into it, which should serve has a slotted screw head for a small key.