Stasis Pod

**Important, No Joke, Please Read**

Seriously, this thing is held together by duct tape, superglue, and the hope of a single South African expat.

This is a 28mm-scale stasis pod – figure **not** included – that I made to serve as an objective marker. Included is a solid version (without an interior) – which *should* be printable on an FDM machine, though I have *not* tested it on one – as well as parts to make a version with an interior, should you wish to add your own figure. The version with the interior has no window, because the idea was for you to make your own out of thin, clear acetate plastic – or food package/blister pack plastic in my case. Cut a square that is approximately **38mm x 30mm**, folding it at both ends using a ruler or another straight edge, leaving a 15mm wide rectangle for the top. These are not exact measurements, but they *should* give you something that is approximately the correct size. Included are presupported files for everything, including the solid