Thingiverse
Static Pressure Gauge
di jadert
0
Download
1
Likes
0
Makes
This is made with the objetive of mesuring static pressure of a 120mm fan.
It is a simple sealed box. On one end, the fan is fixed using a good rubber gasket, and on the other end, a transparent tube is attached. This tube is filled with water to a certain level, which is the 0 point. Then, the fan is turned on. The amount of water that rises represents the static pressure in mm H₂O of that fan.
The hole for the tube had 10mm of diameter, recomend use silicon or other glue to seal the lid and the tube.
The model have no cleareance, so probably you will need do some sanding to make the lid fit
It is a simple sealed box. On one end, the fan is fixed using a good rubber gasket, and on the other end, a transparent tube is attached. This tube is filled with water to a certain level, which is the 0 point. Then, the fan is turned on. The amount of water that rises represents the static pressure in mm H₂O of that fan.
The hole for the tube had 10mm of diameter, recomend use silicon or other glue to seal the lid and the tube.
The model have no cleareance, so probably you will need do some sanding to make the lid fit
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
