Steam Controller Joystick/Thumbstick Mod

Modified version to fit the Steam Controller since the original designer would not share his 3d-models for it.

IMPORTANT: The thumbpads need to be printed with a CONDUCTIVE filament. (I used NinjaTek Eel, but my printer had a hard time dealing with it, as can be seen in the images).

Thumbpads printed with 100% infill since i had better success with that.

Supports were used for the spirals (45 degrees) & holder (70 degrees).

Personally i have not had much use for the left spiral (since there's already a left stick on the controller).