Thingiverse
Steam Controller/Puck Wall mount
von Maramoscabral
0
Downloads
2
Likes
0
Makes
I made this little wall mount for the steam controller/puck
I used two command strips to attach it to the wall, if you prefer, you can add holes in your slicer to bolt it to the wall instead.
I printed mine in PETG for long term mechanical resistance.
5/11/26
Changed the design. The orginal uploaded had a flaw, the puck couldn't get a good connection with the controller and it wouldn't charge.
The V9 should correct this problem.
I used two command strips to attach it to the wall, if you prefer, you can add holes in your slicer to bolt it to the wall instead.
I printed mine in PETG for long term mechanical resistance.
5/11/26
Changed the design. The orginal uploaded had a flaw, the puck couldn't get a good connection with the controller and it wouldn't charge.
The V9 should correct this problem.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
