Steam Deck replacement vent

Wanted to customise the intake vent on my steam deck, and thought the factory intake vent looked a little restrictive.

So i modelled up this. All you need to do is set the modifier to a cutting mesh with 0 top and bottom layers, and this will expose the infill pattern on your print. Chose whatever you like the look of best!

to remove/replace the vent, you need to heat up the plastic rivets with a soldering iron while pushing up from below (i just pushed with my finger) this will release the factory vent, and you can just slide this vent onto the pegs. you can remelt the pegs if you like, but mine was a snug enough fit i didn't bother.