Thingiverse
Steam Time Insert/Organizer
von JMBAKER0020
6
Downloads
4
Likes
0
Makes
The photos show utilization of Sunlu PLA Silk Blue, Sunlu PLA+ Green, Sunlu PLA Silk Yellow, and Inland PLA+ Red. Designed in TinkerCAD.
Print Steam_Time_1_x2 twice....everything else once. Looking at photos you should be able to figure out what fits where, each of them has a spot to put each players pieces, cards, starting gems, and starting money. All the other money, clear gems, and Mr. Time will fit under the green non-player cards seen in green piece in photo. I used the bag holding all non-clear gems, along with the thin long boards to hold all printed pieces from sliding around. Seems to work well for me.
Made small enough to print on average printer bed but still large enough that it won't shift too much in box. It survived my box tilting and turning around, upside-down, etc. It is a little larger than I intended and the box when closed will not be entirely flush, my bad, however it still closes almost all the way and pass the flip the box around test and nothing falls ou
Print Steam_Time_1_x2 twice....everything else once. Looking at photos you should be able to figure out what fits where, each of them has a spot to put each players pieces, cards, starting gems, and starting money. All the other money, clear gems, and Mr. Time will fit under the green non-player cards seen in green piece in photo. I used the bag holding all non-clear gems, along with the thin long boards to hold all printed pieces from sliding around. Seems to work well for me.
Made small enough to print on average printer bed but still large enough that it won't shift too much in box. It survived my box tilting and turning around, upside-down, etc. It is a little larger than I intended and the box when closed will not be entirely flush, my bad, however it still closes almost all the way and pass the flip the box around test and nothing falls ou
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
