SteinMore DeltaMax

This is my version of the following Thing:
https://www.thingiverse.com/thing:923830

You will need parts from the above. The Lower and Upper corners only.

Use 2020 for the uprights (1000mm long x 3 units). 2060 (400mm long 3 units) for the base and 2020 (400mm long 3 units) at the top.

The effector spacing between rods are 60mm. I used 10mm Neodymium magnetic balls glued to the effector and carriers.

Use the "M5 allen cap screw mounts" for a magnetic setup. I used m5 allencap screws inside the mounts. Or you can insert 10mm x 3mm bucket style magnets. Please make sure that you insert your magnets into the mount and rods. Then attach the Magnetic balls to the rods. Only then should you glue your magnet balls to the Effector and carriers. Otherwise you will end up with opposing magnetic fields and the effector will release with the slightest of touch.

Total length for the rods are 400mm on my setup.

Or you can use this effector and the "BallJoint mounts" to convert t