Stepper motor damper V2.0

Hi this is TPU stepper motor damper to make your printer way way quite , I made this so i can print day and night since my printer is near my bed and don't want to be disturbed... i ordered original dampers but they are still on a slow boat from china and i didn't want to wait.... :-D

I used this for my CR-10 printer for X and Y axis only and i needed following materials
8x M3 nut (you will need to insert this into the damper from the inner side)
8x M3 bolt x 5mm length (for thinner stepper motor side)
4x M3 bolt x 8mm length (for mounting X axis sensor on CR-10)
4x M3 bolt x 6mm length (for mounting to Y axis support)

Please don't over tighten your belts as this will make the support to bend and belt slide towards one side, tighten it just so the belt will not slide

hope you enjoy my design