Thingiverse
stepper motor drag chain mount - Atomstack Pro
von mechanic0
141
Downloads
55
Likes
0
Makes
drag chain mount at stepper motor end on Atomstack A5 pro laser engraver.
2 are required. These will snap into place on the stepper motor from the bottom up. no need to use the "bridge piece" that is in the print file.
frame end drag chain mount
2 are required - also need 4 - slot nuts and screws
They are setup to work with 10 x 20 drag chain from amazon
2 are required. These will snap into place on the stepper motor from the bottom up. no need to use the "bridge piece" that is in the print file.
frame end drag chain mount
2 are required - also need 4 - slot nuts and screws
They are setup to work with 10 x 20 drag chain from amazon
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!