Slicer Discord
Stepper Tester Box – 3D-printbaar model van MakerWorld MakerWorld
Electronics

Stepper Tester Box

5 Downloads
1 Likes
1 Makes
Model downloaden
I use this thing to run steppers with the pulse signal generator from MKS :This gadget is a great way to run stepper endlessly and straightforward, for my Filament Winder.The enclosure is to fit :- 1x MKS Stepper Pulse Signal Generator (it's everywhere)- 1x Meanwell LRS 150-24 Power Supply (usually other clones have similar footprint)- 1x DM542 Stepper Driver (can drive nearly any stepper reliably, great torque)- 1x AC SocketFasteners required :- 2x M3x8 (PSU)- 4x M3x8 (Control Board)- 4x M3 Nut (Control Board)- 2x M5x10 (Stepper Driver)- 2x M5 Nut (Stepper Driver)- 2x M3x10 (AC Socket)- 2x M3 Nut (AC Socket)- 2x M3x20 (Lid hinge)The bolt locations are quite straightforward and these screw lengths are not mandatory. You can do anything to get them to mount :) they are just holes in the box. No heat set inserts required. Wiring them is easily looked up on the internet but if anyone wants it I can guide you in the comments.
Categorie
Electronics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie