MakerWorld
Organizers
Model downloaden
Sterilite Bin Latch Replacement - Simplified
24
Downloads
5
Likes
15
Makes
This is a simplified version of the latch for a Sterilite bin. I use the Sterilite gasket bins to store filament after drying, and the hinge pins on the latches tend to break. This version is about 1/8" thick, a little thicker than the original. I printed this out of PETG, and it works well. There are two print profiles, one uses less support and takes a little less time.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!