Thingiverse
Sterlitech Nut Wrench
von circleofowls
1
Downloads
0
Likes
0
Makes
This is a wrench for Sterlitech quick disconnect nuts, aka Fast-Lock Four-Arm Knobs, for those times when you need them more than finger tight.
I'd recommend 5 perimeters and 40% infill for a good strong part, just about any filament will work fine. No supports are needed.
I'd recommend 5 perimeters and 40% infill for a good strong part, just about any filament will work fine. No supports are needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
