Thingiverse
Stick Clip
38
Downloads
42
Likes
0
Makes
Hello all!
This is a clip stick to help clip the first quickdraw on the wall. This part must can be used with your trekking poles to reach the first quickdraw location.
This part was designed to minimize the usage of plastic. So it doesn't require any support or adhesion helper such as brim or raft. Just ensure that the printing bed is clean and everything should be A1. I used 25% infill, but I think this is way overkill.
The gate opener should be made with ~80mm 18 gauge steel wire or bigger since the 18 gauge is just rigid enough to hold the gate open. I provided a folding jig to help fold the wire in a more reproductible manner. Please see the post printing instruction to see how to use the jig. Hope it helps !
Warm thanks to @mottabadass as his parts was used as an inspiration for this part.
Stay safe climbing :)
Regards,
This is a clip stick to help clip the first quickdraw on the wall. This part must can be used with your trekking poles to reach the first quickdraw location.
This part was designed to minimize the usage of plastic. So it doesn't require any support or adhesion helper such as brim or raft. Just ensure that the printing bed is clean and everything should be A1. I used 25% infill, but I think this is way overkill.
The gate opener should be made with ~80mm 18 gauge steel wire or bigger since the 18 gauge is just rigid enough to hold the gate open. I provided a folding jig to help fold the wire in a more reproductible manner. Please see the post printing instruction to see how to use the jig. Hope it helps !
Warm thanks to @mottabadass as his parts was used as an inspiration for this part.
Stay safe climbing :)
Regards,
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!