Thingiverse
Sticker support
von OpenPrint3D
4
Downloads
3
Likes
0
Makes
It is a design to stick 200mm x 105mm stickers without damaging your bike while remaining legible.
Be careful to properly print it out if you are using it on a bike.
Frequently check the integrity or movement of the structure to avoid an accident.
Use it at your own responsibility.
For personns of MONNAIE PLEINE law project, just center it, stick it and cut bords.
http://www.initiative-monnaie-pleine.ch/
Be careful to properly print it out if you are using it on a bike.
Frequently check the integrity or movement of the structure to avoid an accident.
Use it at your own responsibility.
For personns of MONNAIE PLEINE law project, just center it, stick it and cut bords.
http://www.initiative-monnaie-pleine.ch/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!