Slicer Discord
Sticky Note Organiser – 3D-Druckmodell von MakerWorld MakerWorld
Office

Sticky Note Organiser

von Gubis · Office
49 Downloads
30 Likes
23 Makes
Zum Modell
I had a mess on my desk with sticky notes and pens laying around. So I designed this sticky note and pen organiser to take care of that.Sticky notes are staggered horizontally and each compartment is at a different height than the previous one. This allows for easier handling of the sticky notes. The front has a shorter compartment for smaller notes. The side has a compartment for used notes, that you don't quite want to throw away just yet... And of course a pen holder at the back, that I managed to fit a maximum of 18 generic pens into.Yeah it could be nicer looking with rounded edges, maybe it could be optimised to use less material. BUT I printed it once, it worked and I am not wasting anymore plastic on this. So feel free to remix, if you think it's good.
Kategorie
Office
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen