Thingiverse
Stiga Ping Pong Table Corners
door Badadz
1
Downloads
2
Likes
0
Makes
Corners for Ping Pong / Table Tennis tables - This one is specific to STIGA.
- It should fit multiple models with 90mm sides
My Model on the sticker says T8740
Again built this for myself but sharing for any others needing it.
There are 3 images:
Stiga Corner-.stl
Stiga Corner-reversed1.1.stl
Stiga Corner-blank.stl
The first two models you should print 2 of each and it will allow you to have the 'STIGA' brand name on the same side. The blank one is just without the brand so you could print 4 of the same blank ones.
I picked up a table off marketplace and 3 of the corners were damaged (No Problem - 3d Printer to rescue)
- It should fit multiple models with 90mm sides
My Model on the sticker says T8740
Again built this for myself but sharing for any others needing it.
There are 3 images:
Stiga Corner-.stl
Stiga Corner-reversed1.1.stl
Stiga Corner-blank.stl
The first two models you should print 2 of each and it will allow you to have the 'STIGA' brand name on the same side. The blank one is just without the brand so you could print 4 of the same blank ones.
I picked up a table off marketplace and 3 of the corners were damaged (No Problem - 3d Printer to rescue)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!