Slicer Discord
Stim - Apex Legends- Octane – 3D-Druckmodell von Thingiverse Thingiverse
Stim - Apex Legends- Octane – Bild 1 Stim - Apex Legends- Octane – Bild 2 Stim - Apex Legends- Octane – Bild 3 Stim - Apex Legends- Octane – Bild 4 Stim - Apex Legends- Octane – Bild 5 Stim - Apex Legends- Octane – Bild 6
Models

Stim - Apex Legends- Octane

von Tabberoo · Models
486 Downloads
383 Likes
2 Makes
Zum Modell
Here is my first attempt at the stim for Octane. I printed it using my Prusa MK3S.
To get the color changes I added manual filament changes at certain z heights ("add color Change").

For the "Lining_Gray" it kept slipping on the bed. I decreased the pattern spacing to 1.5, the xy separation to 50%, and added a couple support enforcers. It finally stuck (5th time's a charm!). Print 2 of these! Flat sides down, think St Louis Arch.

For the Green cylinder i printed it at 5% Gyroid infill, with horizontal shell set to 3. This made a neat effect when held up to a light.

I glued the pieces together using super glue (Cyanoacrylate).

Good luck. Please share your makes.
Kategorie
Models
Quelle
Thingiverse
Veröffentlicht
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
sehr großer Druck
Einteilig Skalierung/Teilung evtl. nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 3/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
300 mm (Sehr groß)
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen