Stitch head lamp

Stitch head-shaped lamp, easy to make. Can be used as a night light for a child.

The model of lamp I used : https://fr.aliexpress.com/item/1005008942555693.html?spm=a2g0s.12269583.0.0.2f434d8ciBQFGo&gatewayAdapt=glo2fra

Stitch head :

To make the head hollow, I used these settings : 0 bottom layer, 3 top layers, 0% infill, 3 perimeters.

I also added a modifier at the top of the head to increase the number of top layers because, on my first attempt, the print failed at this point because it was too thin and had too much overhang. I printed with a layer height of 0.28 mm.

I had problems with the supports, as you can see in the photo showing the underside of the head. The supports were very difficult to remove and left a lot of marks. So I sanded the underside of the head with my Dremel and made my base so that it hides the problem. I think the problem is partly due to the filament, so if you use a filament that “works better,” please leave a comment.

Base :

I made the base wit