Stitch Lightbox

A Stitch Lightbox.Just adjust the colors to what you want and go ahead and print! I use Sunlu PLA/PLA+ on a majority of my models and have printed at least 1 of each that I upload successfully from the provided profile.Snap the backplate in after putting the light strip in. It is a tight fit, may have to use a little force. Again, model face down and just put some pressure on it. Would suggest focusing on the small little grooves the most, while trying to keep it even all around.If using the stand, the lightbox slides into it. Just apply even pressure and it'll slide in. It's a VERY snug fit! Also, when printing the stand, for some reason it'll prompt you that it requires supports. Think it has to do with the lettering. It doesn't need them. I enabled them and none were printed.Check out my profile as I have been going on a lightbox creation frenzy and will be uploading more lightboxes as I print them and confirm all's good. I'm just getting into this and by no