Stomp Rocket Replacement Rockets

Stomp Rocket Replacement Rockets Over the months, my little one (and her friends) had so much fun with a popular stomp rocket kit that of course we ran out of rockets. Since replacement rockets were tricky to find and were then grossly overpriced, I created this model to replace all those which were accidentally stepped on, were caught by the dog first or just mysteriously vanished. Key dimensions:The rocket body fits on a popular stomp rocket launcher with a max. diameter of ~15.4mm and a length of ~175mm. The inner design diameter of 15.85mm leads to an easy slide on while keeping tolerances tight for a very good flight. Materials:I found it quite important to use TPU for the nose cone as these rockets come down from quite a height. While I did print a few batches in TPU 85A, dialing that in is quite a challenge and requires some additional mods for some of the Bambu printers. So I switched to Bambu's TPU 95A HF which performs really well if dried and calibrated. In my print prof