Thingiverse
Stomper X2
door abadgoat
83
Downloads
68
Likes
1
Makes
This is a scaled up Schaper Stomper.
It was modeled from an original Stomper.
It is exactly twice the size of the original early 80's Stomper.
It runs on 2 "C" cell Batteries.
"Body Mount Tab.STL", "Tire.STL", "Battery Cover.STL", should be printed with Semi-Flex black filament.
The rest of the parts are to be printed with "ABS" or a high strength filament.
Hardware required:
FK-280PA DC motor (This is a Dual Shaft Motor)
3mm X 82mm Axle shaft X2
3mm X 8mm X 4mm bearings X4 (693ZZ bearing size)
Battery Terminals as pictured
SPST PCB switch
Red and Black wire.
Use pictures for assembly.
***UPDATE***
Fixed scale on "Rim Bead MKII" and "Motor Cover MKII".
It was modeled from an original Stomper.
It is exactly twice the size of the original early 80's Stomper.
It runs on 2 "C" cell Batteries.
"Body Mount Tab.STL", "Tire.STL", "Battery Cover.STL", should be printed with Semi-Flex black filament.
The rest of the parts are to be printed with "ABS" or a high strength filament.
Hardware required:
FK-280PA DC motor (This is a Dual Shaft Motor)
3mm X 82mm Axle shaft X2
3mm X 8mm X 4mm bearings X4 (693ZZ bearing size)
Battery Terminals as pictured
SPST PCB switch
Red and Black wire.
Use pictures for assembly.
***UPDATE***
Fixed scale on "Rim Bead MKII" and "Motor Cover MKII".
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
