Stone Spear

Have your main character fight an opponent, such as aT-Rex, as shown in my short film “Hunted” https://youtu.be/XpnR5PGSxbo

Several models of the stone age spear are provided. Select one that suits your requirements and scale it as required. Print the model in the default orientation, however if unsuccessful, rotate the model so that the shone is parallel to the print bed. Print using supports and at least 20% infill. If required, join the pieces using dowel and a suitable adhesive, such as epoxy. Clean up the model and paint in your preferred colour scheme.

For a full size print, a model with a short length of 19mm (3/4 inch) shaft is included. Attach this print to a 19mm dowel, as is typically found on a broom handle. Tweak the scale for a perfect match, alternately fill-and-sand the joint.

The v01 stone spear was initially modelled in Maya and the v02 model was cleaned up using primarily MeshMixer and ZBrush.