Thingiverse
Storage Box for Calibration Weights
von Artino
0
Downloads
0
Likes
0
Makes
A storage container for those cheap calibration weights from Aliexpress (20-10-5-2-1g)
To hold the lid shut, i used the tiny magnets from Dexcom G7 Sensor applicators but you can also get a bunch of 5 x 1.5 mm magnets on AliExpress.
For the hinge bolts i used the threaded ends of 2 mm bicycle spokes. I mounted them by turning them in with pointy pliers but you can also use any 2 mm rod and glue it on to one side of the hinge.
Hinges have 45° overhangs and should print without support
To hold the lid shut, i used the tiny magnets from Dexcom G7 Sensor applicators but you can also get a bunch of 5 x 1.5 mm magnets on AliExpress.
For the hinge bolts i used the threaded ends of 2 mm bicycle spokes. I mounted them by turning them in with pointy pliers but you can also use any 2 mm rod and glue it on to one side of the hinge.
Hinges have 45° overhangs and should print without support
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
