Thingiverse
Storage Crate (Vase mode)
door Mr_JoerT
64
Downloads
41
Likes
1
Makes
Vase mode print of a storage crate. The model was optmised so vertical angles are no greater than 45 degrees off the horizontal.
There are ofcourse some compromises in the design to decrease these angles, but I think the end result is still craty enough.
*Use vase mode or Spiralize outer contour, or you will end up with a solid block of crate-shaped plastic!*
Scale as desired. I've printed these at 60mm³, 100mm³ and 120mm³. Just make sure to scale Z at the same or greater rate as X and Y, or your vase will fail (for example, You can print one at 100 wide, 60 deep and 100 high, but not at 100 wide, 60 deep and 60 high, as increasing the width relative to the height will increase the angle and will likely make the vase fail.
There are ofcourse some compromises in the design to decrease these angles, but I think the end result is still craty enough.
*Use vase mode or Spiralize outer contour, or you will end up with a solid block of crate-shaped plastic!*
Scale as desired. I've printed these at 60mm³, 100mm³ and 120mm³. Just make sure to scale Z at the same or greater rate as X and Y, or your vase will fail (for example, You can print one at 100 wide, 60 deep and 100 high, but not at 100 wide, 60 deep and 60 high, as increasing the width relative to the height will increase the angle and will likely make the vase fail.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
