Thingiverse
StormTrooper Salt-Pepper
von rkevinball_5591
14
Downloads
9
Likes
0
Makes
I started with: https://www.thingiverse.com/thing:4543747 I had to rework the base and hollow it out. I made a screw-in cork.
You will have to drill the holes in the top: Salt (3-holes) and Pepper (2-holes)
Print the helmet @ ZERO% infill
Print the cork @ 100% infill
I scaled it down to 66% in CURA. Remember to scale the helmet and the cork the same.
If you wish, you can print it full size.
I did not have white ABS so I printed it and painted it white.
You will have to drill the holes in the top: Salt (3-holes) and Pepper (2-holes)
Print the helmet @ ZERO% infill
Print the cork @ 100% infill
I scaled it down to 66% in CURA. Remember to scale the helmet and the cork the same.
If you wish, you can print it full size.
I did not have white ABS so I printed it and painted it white.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
