Stranger Things pinball mods

I printed the left billboard mod face down with support. I chose to paint the ring on mine in glittery red, but solid black would look fine. Darkstar 9 by Elite Screens is the screen material used (must be cut in the correct direction--a 90 degree spin will reveal the ambient light rejecting direction).

Remove the old sticker decal before applying.

I used foam mounting tape (super glued the tape to the mod, but just the tape to the ramp, so it's reversible). You'll need to recalibrate your projector for the billboard after installing.

The bulb cones are NOT plug and play. I intentionally made them on the small side, and quickly heated them up with a lighter and pressed them to fit the bulb, then super glued (gel) them into place. The ones in the right side sling I cut to fit (shown in photos).