Thingiverse
Strap Buckle (25 mm)
door 50inchsausage
86
Downloads
84
Likes
0
Makes
Hi there!
I found couple of buckles here on thingiverse but none was printable without support or/and was not in size I needed so here is my simple take on this.
I printed it with PETG at 0,1 layer height. I will use two of those to attach sleeping bag on my backpack so I guess 50% infill is just enough.
I found couple of buckles here on thingiverse but none was printable without support or/and was not in size I needed so here is my simple take on this.
I printed it with PETG at 0,1 layer height. I will use two of those to attach sleeping bag on my backpack so I guess 50% infill is just enough.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
