Thingiverse
Strap With Loop
4
Downloads
1
Likes
0
Makes
Temporary upload for auto bed clearing experimentation.
Do NOT just run the gcode. It needs start and finish code added from the sliced STL.
Align the Angled strap file in your slicer in the bottom left. Put the bottom all the way down (Y0.00) and the left nub 21mm from the left side (X21.00). That should get you close.
Do NOT just run the gcode. It needs start and finish code added from the sliced STL.
Align the Angled strap file in your slicer in the bottom left. Put the bottom all the way down (Y0.00) and the left nub 21mm from the left side (X21.00). That should get you close.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!