Thingiverse
Stratux ADS-B Casing
par Kevintjuh
49
Téléchargements
27
Likes
0
Makes
Hi All,
First I printed the Stratux Nano Dual SDR Case by Mistertech. (love the layout and concept of the case!)
Personally I missed a fan because the temperature in no-time raised above 70 degrees celcius, and also wanted a bit more space at the antenna cables.
So I used Siemens NX to re-draw Mistertech's design.
This case is a little bit higher to gain a bit more clearance for the fan, which is attached to the cover of the case.
Also I had a lacking and disturbed GPS signal, that's why I created a hole in the top shell (within the Stratux logo) right above the internal GPS unit.
To diminish the chance of magnetically disturbance from the LAN connector and Radio high gain antenna’s I have drawn an GPS shield, which I have covered up with copper tape, this is connected to by wire to one of the ground pins.
For the top of the case I tried “3DLAC spray adhesive” on the bedplate of the Ultimaker 3. Unfortunately I used a bit too much causing the top to look a bit dir
First I printed the Stratux Nano Dual SDR Case by Mistertech. (love the layout and concept of the case!)
Personally I missed a fan because the temperature in no-time raised above 70 degrees celcius, and also wanted a bit more space at the antenna cables.
So I used Siemens NX to re-draw Mistertech's design.
This case is a little bit higher to gain a bit more clearance for the fan, which is attached to the cover of the case.
Also I had a lacking and disturbed GPS signal, that's why I created a hole in the top shell (within the Stratux logo) right above the internal GPS unit.
To diminish the chance of magnetically disturbance from the LAN connector and Radio high gain antenna’s I have drawn an GPS shield, which I have covered up with copper tape, this is connected to by wire to one of the ground pins.
For the top of the case I tried “3DLAC spray adhesive” on the bedplate of the Ultimaker 3. Unfortunately I used a bit too much causing the top to look a bit dir
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !