Straw Cup

**Newest Update: I had to man-mode those feet into place. Essentially, I had to place each foot on a flat surface, line up the hole in the base while holding it parallel to the flat surface, lay the flat of my scraper across the top of it, place the palm of my hand onto the top of the scraper, and start putting weight onto it until it popped into place. I went back and looked at my file, thinking I needed to increase the tolerance for the feet, but, as it turned out, I had put zero tolerance into the redesign. I have fixed the stl and uploaded it.**

**Update 2: I fixed the problems with the feet. I haven't printed them yet, but I'll post pictures once I have. Probably tomorrow.**

**Update 1: There's a slight problem with the feet for this design. Upon printing in a different material, the fit was so tight that one of the feet broke off. I am currently working on fixing this by creating wider legs that are less affected by the jerk of the extruder assembly.**

Just a sm