Straw Dispenser

We have a few reusable straws and I created this dispenser for them. Just drop the clean straws on top and they are transported down the slide ready for pickup. Straws should not have an outer diameter larger than 10mm (mine had ~7.5mm). Has holes for tiny mounting screws (I used 2.5 10 flat heads). Print it twice and mirror it once using your printing software. The width of each side is 40mm. In case you have varying straw lengths, ensure that the gap between the holders is larger than the shortest straw. This means the difference of longest and shortest straw must be less than 40mm (otherwise it can fall down). I do not think it will work for bent straws.

Does not require supports (holes are small enough). Print it with the side up as shown in the 3d images.