Thingiverse
Stream Deck 20° Holder
door k3xx
13
Downloads
15
Likes
0
Makes
A holder for the 15 key, mk2 stream deck.
The original one was moving around on my desk because it holds the SD in steep angle. This one holds it in 20° angle with minimal height.
There are 9 places marked on the bottom for rubber feets.
My print settings:
0.6 mm nozzle
0.2 layer height
3 walls
5 top and bottom layers
15% infill
Fuzzy skin only on the outside with 0.2 thickness and 0.2 point distance
The original one was moving around on my desk because it holds the SD in steep angle. This one holds it in 20° angle with minimal height.
There are 9 places marked on the bottom for rubber feets.
My print settings:
0.6 mm nozzle
0.2 layer height
3 walls
5 top and bottom layers
15% infill
Fuzzy skin only on the outside with 0.2 thickness and 0.2 point distance
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!