Stream Deck Low Profile Stand

Simple low profile stand for the Elgato Stream Deck Mk1. It's designed so that the stream deck sits at a 25 degree angle, flush against the front surface. It's a tight but secure fit for me so I included a test fit piece since everyone's printer is different. After figuring out how much you need to adjust the dimensions on the test piece, do the same for the stand by first placing the front face on the bed of your slicer, making the same adjustments you made for the test piece, then reorienting the stand right side up. Note that since the face is at an angle, it may also introduce some varying tolerances as well. No supports are needed and the longest bridge is shy of 20mm. Just make sure that your slicer makes that first bridge layer oriented across the gap (most likely it'll count as a perimeter and should behave that way anyways)

Note: This was made for the Stream Deck Mk 1. I have not tested this on the Mk 2.

Printing:

I printed with 0.2mm layer height, 3 perimeters and 15