Stream Deck Plus Plus

Combine an Elgato Stream Deck and Stream Deck Plus into a single device! Compatible with Stream Deck Mk1 and Mk2 (not scissor key).

Start by printing a Stream Deck Vertical Mount "SDPlus" variant, available here:
https://www.thingiverse.com/thing:7140069

The models are oriented for the Stream Deck on the left, rotated 90 degrees anticlockwise. Mirror both the mount and overlay model in the slicer to use with the Stream Deck on the right.

The overlay is intentionally thin (0.4mm) but should print successfully with standard quality 0.2mm layers. Allow the heated bed to cool thoroughly before attempting to remove the print to avoid warping/stretching. If you have quality issues, use 0.1mm layers, or if necessary increase the thickness by scaling along the Z axis in your slicer.

For proper alignment, a 1-2mm thick self-adhesive non-slip pad should be applied to the bottom of the Stream Deck vertical mount.

Ultra-thin double-sided tape is recommended to attach the overlay to the two St