Thingiverse
Stream Deck robust holder/stand (parametric, multiple configuration)
von truhlik_fredy
97
Downloads
75
Likes
2
Makes
This is a robust and solid holder for Elgato's Stream Deck (not the mini, not XXL).
**UPDATE**: Added a v3 almost vertical super tall variant (75 degrees) of the holder, this variant will probably require support to be printed (didn't test it myself yet).
**UPDATE**: After users testing the 75 degrees variant, there was a flaw in the design, but now it should be fixed.
Was frustrated with existing holder being to fiddly and collapsing on itself when I wanted to move it on the desk (tend to do it often). And seeing a lot of holders which are not steady enough, or have extra stuff I do not need or are just plain wasteful, have logos, unnecessary geometry (some are more ornaments and are more fashion statement than just a holder). So I decided to make my own function over the form holder, there are 4 variants of it, two with hollow bottom and two solid bottom and then each permutation with shallow angle and with steep angles (parametric source allow you to adjust your own angle,
**UPDATE**: Added a v3 almost vertical super tall variant (75 degrees) of the holder, this variant will probably require support to be printed (didn't test it myself yet).
**UPDATE**: After users testing the 75 degrees variant, there was a flaw in the design, but now it should be fixed.
Was frustrated with existing holder being to fiddly and collapsing on itself when I wanted to move it on the desk (tend to do it often). And seeing a lot of holders which are not steady enough, or have extra stuff I do not need or are just plain wasteful, have logos, unnecessary geometry (some are more ornaments and are more fashion statement than just a holder). So I decided to make my own function over the form holder, there are 4 variants of it, two with hollow bottom and two solid bottom and then each permutation with shallow angle and with steep angles (parametric source allow you to adjust your own angle,
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
