Thingiverse
Streamdeck and USB Knob Desk Insert
von Melachiah
3
Downloads
4
Likes
0
Makes
By popular demand from 3d printing groups, I've uploaded my drop in desk insert for my Streamdeck and volume knob.
The knob I'm using is one of the many volume knobs available on Amazon, they're all pretty much the same.
The insert supports a standard 15 key Streamdeck.
I wouldn't recommend using this insert as is if your desk isn't at least 35mm thick.
This drops in to a cut out made into your desk that needs to be about 215mm long x 90 mm wide and 30mm deep. The back 20mm of the cut out goes all the way through the desk, allowing cables to drop down cleanly.
The knob is inserted from below, simply pull the knob off, insert the knob from beneath, slot the lock in place, and put the knob back on.
The Streamdeck drops in from the top and can be easily removed.
The knob I'm using is one of the many volume knobs available on Amazon, they're all pretty much the same.
The insert supports a standard 15 key Streamdeck.
I wouldn't recommend using this insert as is if your desk isn't at least 35mm thick.
This drops in to a cut out made into your desk that needs to be about 215mm long x 90 mm wide and 30mm deep. The back 20mm of the cut out goes all the way through the desk, allowing cables to drop down cleanly.
The knob is inserted from below, simply pull the knob off, insert the knob from beneath, slot the lock in place, and put the knob back on.
The Streamdeck drops in from the top and can be easily removed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
