STREET SHARK

Hi guys, I modeled this Street Shark, a cartoon from my childhood. The model is divided into parts so it can be printed without AMS. All the pieces are snap-fit with tolerances of ±0.2 mm, so please pay attention because not all of us have a perfectly consistent filament flow. If the parts feel too tight, slightly reduce the scale percentage in your slicer.Remember to use glue to secure the pieces together.For the jacket, it may seem like the body doesn’t fit, but you just need to apply a little pressure and it will slide in and sit properly in place. The same goes for the teeth—gently find the correct position and they will fit easily.I hope you like the model, and a BOOST is always greatly appreciated 😉