Thingiverse
String test gcodes for Ender-3
por hmate
104
Descargas
43
Likes
0
Makes
This is a stringing test piece I created, the 40mm distance between the column centers is a good distance to fine-tune the retraction settings.
I included the STL if you would like to slice it yourself.
The G-Code files are made for my Ender-3, but i think it is compatible some other printers too (I am not an expert, so I cannot say for sure).
The first layer is set to 240 C° hot end and 80 C° bed, then the rest of the layers are on 220 C° hot end and 70 C° bed. If you want to change these temperature settings, open up the G-Codes in a text editor and change the values at the following gcodes:
Bed: M140(first two instances), M190 (one instance)
Hot end: M104(first two instances), M109 (one instance)
Once edited just stick it on an SD card and off you go.
The attached g-codes have descriptive names, so it should be straight forward which one you select.
The retraction speeds range from 20 mm/s to 50 mm/s.
There are two prints for each speed:
One from 0-4 mm
I included the STL if you would like to slice it yourself.
The G-Code files are made for my Ender-3, but i think it is compatible some other printers too (I am not an expert, so I cannot say for sure).
The first layer is set to 240 C° hot end and 80 C° bed, then the rest of the layers are on 220 C° hot end and 70 C° bed. If you want to change these temperature settings, open up the G-Codes in a text editor and change the values at the following gcodes:
Bed: M140(first two instances), M190 (one instance)
Hot end: M104(first two instances), M109 (one instance)
Once edited just stick it on an SD card and off you go.
The attached g-codes have descriptive names, so it should be straight forward which one you select.
The retraction speeds range from 20 mm/s to 50 mm/s.
There are two prints for each speed:
One from 0-4 mm
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
