Thingiverse
Stringing Retraction Test with numbers
door Tinkerrific_Com
5
Downloads
2
Likes
0
Makes
These are small double-towers for your stringing test, the number on each part is for reference. DON'T FORGET to actually set the retraction value to the number of the part you're printing with that setting.
Best use "print separately" setting with per-model settings overrides, but that is not supported in newer CURA versions, so I had to use 3.5.1
Best use "print separately" setting with per-model settings overrides, but that is not supported in newer CURA versions, so I had to use 3.5.1
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!