Stripper Clip Speed Loader

This is a stripper clip speed loader for 5.56 NATO/.223 Rem/.300 BLK AR-15 magazines.*If you do not need the loading arm to be retained, then you do not need the locking plate or screw.PRINT- Body- Loading Arm- Locking Plate*BUY- M3x0.5 6mm Screw*ASSEMBLY1) Install the Loading Arm Hold the body with the flat solid side down. Place the loading arm with the lug facing up against the slotted opening on the small end of the body. Then angle the handle of the loading arm up and with a bit of force push it into the body.2) Install the Locking Plate* Start by pulling the loading arm partially or fully back without removing it. Stick the locking plate below the arm, inside the body and above the small hole on the bottom of the body so that the hole in the locking plate meets up with the hole in the body. You want the locking plate to be approximately flush with the end of the body it goes into. Next screw the M3x0.5 6mm screw from the bottom of the body through the small hole into the locking