Thingiverse
Strong Clothespeg
by Inicus
339
Downloads
244
Likes
0
Makes
Was disappointed with other designs not having enough spring pressure, or just not fitting my clothesline. So designed this version.
Print in place without supports.
Assembly instructions: Wait until cooled down, then push the spring at the back end into the hook/slot/notch and the jaws should now be completely closed (the millimeter gap was necessary to print them without them joining together).
Included two versions with differing amounts of spring pressure, and also the step files of the peg without the spring, and the spring itself, so that you can tweak the size and angle of the spring to change the amount of pressure it exerts on the jaws.
Print in place without supports.
Assembly instructions: Wait until cooled down, then push the spring at the back end into the hook/slot/notch and the jaws should now be completely closed (the millimeter gap was necessary to print them without them joining together).
Included two versions with differing amounts of spring pressure, and also the step files of the peg without the spring, and the spring itself, so that you can tweak the size and angle of the spring to change the amount of pressure it exerts on the jaws.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
