Thingiverse
Strong Door Hanger
von freddie_frog
0
Downloads
2
Likes
0
Makes
Strong Over Door Hanger
Hi! Here is my design for an over door hanger that’s strong enough to take even the fullest of stockings!
Designed to fit 35mm wide doors with no fixings or modifications to the door needed.
The front face has a flat section so if you want, you can add your own decorations or name plates easily.
For the example in the photos, I used ELEGOO PLA Matte in Beige.
If you have a BAMBU LAB printer, you can print direct to you printer here:
https://makerworld.com/en/models/853564#profileId-802212
Recommended settings:
Print on its side
Supports added
20% infill (although I think the normal 15% would be fine too)
2 outer shells
5 layers top and bottom
Happy Printing! 😊
Hi! Here is my design for an over door hanger that’s strong enough to take even the fullest of stockings!
Designed to fit 35mm wide doors with no fixings or modifications to the door needed.
The front face has a flat section so if you want, you can add your own decorations or name plates easily.
For the example in the photos, I used ELEGOO PLA Matte in Beige.
If you have a BAMBU LAB printer, you can print direct to you printer here:
https://makerworld.com/en/models/853564#profileId-802212
Recommended settings:
Print on its side
Supports added
20% infill (although I think the normal 15% would be fine too)
2 outer shells
5 layers top and bottom
Happy Printing! 😊
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!